On the Panigale V4, the handlebar ends near the fork is a big screw/bolt that tightened the handle bar to the bar clamp so we can't use this Rizoma brake fluid reservoir bracket... is the V2 handlebar tightened differently? (maybe with pinch bolt like the old 998?)
Ohhh good point, hrrrmm wonder how I can mount mine to retain the factory fluid reservoir?
Had a set of these on my 1199 when I fitted some Rizoma reservoirs. I am not sure they will work on the V4 however due to the allen bolts/caps in the end of the handlebar tubes. The 1199 just had plain end caps fitted plus the ends of the V4 tubes are threaded internally. You COULD drill and tap a hole into the centre of the existing V4 plug, ditch the rubber sleeve and conical nut/washer and just bolt the bracket to the end cap as a way around the issue.
Have ordered the Rizoma bar end mounting brackets apparently they are suited for the V2, will also share information once installed.
just installed these on my 1299. i had to modify they angled bracket that the res mount on as my AEM res are a little different. they mount right in the inside end of the handle bars. so far so good.
Got any blackerWow, you even ordered the Dynamoto stand in matching black
this project thus far has been enjoyable really can’t thank you all for the support and information you all share, appreciate it fellas
For me, when I am draining brake fluids first:
That is replacing your current banjo bolt on (the bolt that hold your clutch hose to the clutch master cylinder).
I’ll investigate where I plug the plug into
Are the M7RS aluminum or magnesium?
Very nice
