My little build

[HKMP7]

Once they smooth out the AFR. That power curve should be super linear.

 

[Brooklynv4]

Well I’m back boys cleaned up the throttle response gained about 5 hp in each gear and roped out at 195

 

[Brooklynv4]

 

[BMW Alpina]

View attachment 8534

Nice gain @Brooklynv4
You are doing custom dyno tune, right? May I know who is your tuner?
Thanks

 

[Brooklynv4]

Yes custom using woolich. Anthony at Bauce racing is my tuner. He’s in nj for anyone on the east coast.

 

[HKMP7]

Awesome that graph looks super smooth. Good job smoothing out that dip between 12,500-13,000

 

[Brooklynv4]

Bike feels amazing now definitely money well spent. I was targeting that dip and smoothing everything out. The 195 was a bonus

 

[bp_SFV4]

Next up were some carbon lever guards from lightech as well and an nrc fender eliminator kit
View attachment 4565

I had the thought of doing something similar to get my bike to the track without going full on toy trailer that I have no where to store. I take it you have a chock on the front? Have you had any problems transporting it this way?

 

[Brooklynv4]

Honestly it’s the best way pitbull restraint. No I didn’t have a chock. Just used a one inch sheet of plywood put the plate on and a 2x4 behind the screws of the plate on the bottom side so the screws won’t scrape on the floor. Takes 5 minutes to load the bike

 

[bp_SFV4]

No issues getting it up a U-Haul ramp?

 

[Brooklynv4]

I have a folding ramp I bought from cycle gear just roll it right up into the restraint lock it up and you’re off to the races

 

[craig bush]

No issues getting it up a U-Haul ramp?

The Pitbull TRS base is bolted to the trailer floor - not really feasible with a rented trailer.

 

[Brooklynv4]

I bolted it to a sheet of plywood and just layer the plywood on the floor of the trailer bike didn’t budge from ny to Florida

 

[Brooklynv4]

*layed

 

[craig bush]

I bolted it to a sheet of plywood and just layer the plywood on the floor of the trailer bike didn’t budge from ny to Florida

Oh, shut my mouth. Well done.

 

[Brooklynv4]

Back for some advice from you guys. I ran the rear brake line I got from Brad but I’m thinking of taping the swing arm for another anchor point as it look like the line is close to the wheel

 

[Brooklynv4]

here are some more pics with the wheel off

 

[Brooklynv4]

I’m going to try and un it under the chain guard and see how that works out. I don’t need mother issue like the one I just went through lol

 

[Brooklynv4]

*another

 

[HKMP7]

If you cant get it under the chain guide you can use these.

Clean the swingarm use some adhesion promoter and a couple zip ties.